MK Diamond MK-370 EXP - Manual (Page 34)

34
1/2-inch Wrench
(B)
Inspect Tile Saw
for damage
If alignment problems are the result of a warped blade, a bent frame or bent support arm,
or, if alignment is off by more than 1/8-inch, contact the MK Diamond Service Center -
(800) 474-5594
Combination Square
12-inch or Greater
Flat Head Screwdriver
1/4-inch Wrench
(A)
Remove Tile Saw
from Power Source
(C)
Inspect Diamond Blade
for damage
The Movable Cutting Table of the MK-370EXP Saw is pre-aligned in the factory. It may become
misaligned with the Cutting Head of the Tile Saw over time. Should misalignment occur, perform the
following steps to realign it.
TOOLS NEEDED:
PREPARATION
ALIGNMENT
MK-370EXP SAW TROUBLESHOOTING
NOTE: