MK Diamond MK-370 EXP - Manual (Page 38)

38
45° ALIGNMENT VERIFICATION
If the blade is misaligned following this alignment procedure, return the saw to MK Diamond for
repair. The Diamond Blade must be removed and reinstalled when removing the Blade Guard.
The 45° Alignment Verification is done to ensure the blade will cut tile at a 45° angle.
(B)
Position the Cutting Head
to the 45° Cutting Angle
(A)
Remove Blade Guard
(If not done Previously)
(C)
Place Square on the Movable
Cutting Table and position the
Square against the Blade
(E)
To Adjust 45° Cutting Angle,
locate the 45°Adjustment
Screw
(D)
Verify Blade is even
across all points of Square
and there are no gaps
between Blade and Square
(F)
Rotate 45° Adjustment Screw
clockwise or counter-clockwise
to realign 45° Cutting Angle
(G)
Verify Blade is now even
across all points of Square
(H)
Repeat steps A to G until Blade is
even across all points of Square
MK-370EXP SAW TROUBLESHOOTING
NOTE: