MK Diamond MK-145 - Manual (Page 12)

12
UNPaCKiNG:
Your MK-145 has been shipped from the factory thoroughly inspected. Only minimal assembly is required.
If not done, remove the MK-145 from the box and place on a flat surface. Remove the Water Basin,
Cover (See Step 1 of the Blade Guard Installation Procedure; page 13.), and remove the accessories
package from the Water Basin.
Use proper lifting techniques when lifting the MK-101.
CONTeNTS:
In your container, you will find one (1) MK-145, one (1) 4-1/2 inch diamond blade, one (1) metal inner
flange, one (1) plastic outer flange, one (1) retaining nut, (1) 45º cutting guide one, (1) adjustable
cutting guide, two (2), adjustable cutting guide retaining knobs, one (1) adjustable blade guard, one
(1) blade guard retaining screw, one (1) MK-145 table stop, one (1) blade wrench, one (1) owners
manual, and one (1) warranty card
TRaNSPORT:
The MK-145 weighs approximately eleven (11) pounds, making transport easy.
Never transport the MK-145 with water in the Cooling Basin.
The MK-145 is designed with recessed edges in the molded plastic case for ease of transport. To
transport the MK-145, simply grasp it by the two recessed edges, lift and move it to the desired location.
CAUTION
MK-145
45° Cutting
Guide
MK-145
Table Stop
Diamond Blade
Adjustable
Cutting Guide
Blade Wrench
www.mkdiamond.com
Caution: Read all safety and operating instructions before using this equipment. This owner’s manual MUST accompany the equipment at all times.
Revision 100
MK-145 Tile Saw OWNERS MANUAL, PARTS LIST & OPERATING INSTRUCTIONS
05.2011 Manual Part# 158286
Metal Inner
Flange
Adjustable
Cutting Guide
Knobs
Owners
Manual
Plastic Outer
Flange
Blade Guard
Warranty Card
Retaining Nut
Blade Guard
Retaining
Screw
MK-145 ASSEMBLY
CAUTION