MK Diamond MK-145 - Manual (Page 23)

23
MK-145 TROUBLESHOOTING
TROUBleSHOOTiNG:
Turn the ON/OFF switch to the OFF position and unplug the saw from the power
source before performing any troubleshooting procedure.
Motor Stops Turning:
WARNING
(A)
If not fully connected,
reconnect plugs and
turn on the saw. If fully
connected, go to step B
(E)
If power source is not at
120V move the saw to
another circuit and
turn on the saw
(B)
If the GFCI is tripped reset
it and turn on the saw. If
the GFCI is not tripped,
go to step C
(C)
If the circuit breaker is not
15 amps, move the saw to
a 15-amp circuit breaker
and turn on saw. If the
circuit breaker is 15 amps,
go to step D
(D)
If tripped, reset the
breaker once and turn on
the saw. If the saw trips
again, proceed to step F.
If the circuit breaker is not
tripped, go to step E