MK Diamond MK-145 - Manual (Page 15)

15
MK-145 SETUP
SeTUP:
• Before powering or starting, check for damage, that could prevent this equipment from proper
operation or performing its intended function. Check for binding and improper alignment of
moving parts. Check for damaged, broken, or missing parts.
• Verify the On/Off switch is in the OFF position.
• Before connecting the MK-145 to a power supply, be sure the voltage, cycle and phase of the
job site power source meet the requirements of TABLE 3.
• If using an extension power cord, ensure sure the length and wire gauge correspond to the
requirements listed in TABLE 1 on Page 9. An extension power cord that is too small in wire
gauge (diameter), or too long in length, will cause the motor to overheat and could cause
premature failure.
• Use an approved Ground Fault Circuit Interrupter (GFCI).
• Do not cover the motor vents as this could lead to motor overheating.
• Do not overfill the Cooling Basin.
NOTe: In order to avoid breaker tripping, a 15-amp circuit breaker should be used.
CAUTION
Voltage 120V
Cycle 60 Hz
Phase: 1-phase
Table 3
(A)
Place MK-145 on a flat,
level surface and verify the
Diamond Blade is aligned
with the Blade Guard
Support Angle using
straight edge
(B)
Loosen the Blade Guard
Support Screw and align
the Blade Guard to the
Diamond Blade then
retighten the Blade Guard
Support Screw
(C)
Lift Water Basin Cover and
pull out on Water Basin
Cover to remove