MK Diamond MK-2000 - Manual (Page 19)

MK-2000 Revision 03/05, Effective Date March 21, 2005 Page 19
SETUP, ADJUSTMENT and OPERATION
2. Chop Cutting:
A Chop Cut is performed by cutting completely through an object in one pass.
Note: Skip steps E and F, if cutting dry.
(J)
Turn the Saw off when cutting
is complete
ON/OFF
Switch
OFF
Position
(C)
Verify the Masonry Piece is
seated against the Ruler/Stop
and the Adjustable Cutting Guide
(A)
Set the Adjustable Cutting Guide
to the desired length indicated
on the side of the Ruler/Stop
closest to the Wooden Strip
(D)
Place the ON/OFF Switch in
the ON position
(F)
Verify cooling flow exists on
both sides of the blade
(E)
Open the Cooling Flow Control
Valve and adjust cooling flow
Ruler
Markings
Measuring
point
Ruler/Stop Adjustable
Cutting Guide
(B)
Place the Masonry Piece onto
the Movable Cutting Table
Masonry Piece Masonry Piece Adjustable
Cutting Guide
Ruler/Stop
ON/OFF
Switch
OFF
Position
Control Valve
Cooling Flow
Points