MK Diamond PX-3 - Manual (Page 12)

12
The PX-3 Paver Saw is equipped with a number of safety decals. These decals are provided for operator safety
and maintenance information. The illustration below also shows the location of these decals. Should any of
these operation or safety decals become unreadable, replacements can be obtained by calling (800) 262-
1575.
OPERATION & SAFETY DECALS
WARNING
Grinding/cutting/drilling of masonry, concrete, metal and other materials with silica in
their composition may give off dust or mists containing crystalline silica. Silica is a basic
component of sand, quartz, brick clay, granite and numerous other minerals and rocks.
Repeated and/or substantial inhalation of airborne crystalline silica can cause serious
or fatal respiratory diseases, including silicosis. In addition,California and some other
authorities have listed respirable crystalline silica as a substance known to cause cancer.
!
DO NOT operate
this equipment
before reading
the owners’
manual!
WARNING !
NOTICE
Most Motor Problems are caused by improper
voltage and extension cords. Cord should be
one-piece and short as possible. Cord
selection should match the following table.
1-2 H.P.
25’
50’
75’ 100’
150’
250’
Max. Cord Length
Max. Cord Length
Max. Cord Length No. 12 Wire
No. 10 Wire
No. 8 Wire
115v 230v
Decal C
Decal A
Decal B
Figure 5. PX-3 Masonry Saw Safety Decal Sheet, Part No. 166011
PX-3 PAVER EXTREME SAFETY