MK Diamond PX-3 - Manual (Page 19)

19
PX-3 PAVER EXTREME OPERATION
CHOP CUTTING
1.
2.
3.
4.
5.
6.
Position the Back Stop for a cross cut or rip cut.
Position the work against the Back Stop.
Depress the Trigger Switch to start. Lower the Cutting Head to begin cutting.
Continue lowering the Cutting Head until the cut is complete.
When cutting is complete, raise the Cutting Head and release the Trigger Switch. ALWAYS allow the Blade
to stop moving before removing work.
Remove work from the cutting area.
CROSS CUTTING
A chop cut is performed by cutting completely through an object in one pass. The following section describes the
correct procedure for performing a chop cut.
1.
2. Ensure that the Back Stop is in the Forward position for Cross Cutting (Figure 15).
Position the work against the Back Stop and perform the Cut (Figure 16).
Fig. 15 Back Stop in the Forward position Fig. 16 Position work and perform cut