MK Diamond MK-2005G - Manual (Page 21)

MK-2005G Revision 12/00, Effective Date December 26, 2000 Page 21
SETUP, STARTUP, ADJUSTMENT, OPERATION and SHUTDOWN
3. Cutting with the Cutting Head Locked Down:
This method is preferred when cutting small objects.
DO NOT FORCE TOOL, it will do the job better and safer at the rate for which it was designed.
Note: Skip steps D and E, if cutting dry.
(J)
Move the Throttle Lever to lower
blade speed
Direction of
Movement
(J)
Raise Cutting Head once
cut is complete
Raise Cutting
Head
(H)
Continue lowering the
Cutting Head until the
cut is complete
(G)
Lower Cutting Head
to begin the cut
(B)
Position the masonry piece
(A)
Set the Adjustable Cutting Guide
(C)
Lock Cutting Head in
the down position
Hold Cutting
Table Stationery
Lower Cutting
Head Smoothly
to Cut
Continue to Lower
Cutting Head until
Cut Complete
Set Edge of Cutting
Guide to Desired Cut
Length on Ruler/Stop
Set against Adjustable
Cutting Guide and
Ruler/Stop
Ruler Markings
Adjustable
Cutting Guide
Ruler/Stop
Lock Cutting
Head in down
position
Loosen Locking
Handle to adjust
Cutting Head
Throttle Lever
Ruler/Stop