MK Diamond MK-2005G - Manual (Page 45)

MK-2005G Revision 12/00, Effective Date December 26, 2000 Page 45
MAINTENANCE AND TROUBLESHOOTING
TROUBLESHOOTING:
Turn the ON/OFF switch to the OFF position and place the Fuel Valve in the CLOSED position
before performing the following.
1. Blade Will Not Cut Properly:
2. Movable Cutting Table Does Not Move Correctly:
Return to
MK Diamond
for Repair
(B)
Check for Proper Rotation
(A)
Check for Smoothness
or “Glazing”
(E)
Return to MK Diamond
(D)
Verify Blade Correct for
Material Being Used
(C)
Ensure Blade
Core Not Bent
If Rotation
Correct, go
to Step C
If not “Glazed,
go to Step B
If “Glazed,” Dress
(See Blade Dressing)
If Core Not
Bent, go to
Step D
If Core Bent,
Change Blade
If Blade
Correct, go
to Step E
Contact Place of Purchase or
MK Diamond (800 421-5830)
To Verify Blade
(B)
Check the Movable Cutting Table
Roller Wheels and replace if
necessary
(A)
Check that the Guide
Rails are clean and
clean if dirty
Return to
MK Diamond
for Repair
(E)
Return to MK Diamond
Guide Rail
Roller Wheels
Rotation Direction