MK Diamond MK-2005G - Manual (Page 23)

MK-2005G Revision 12/00, Effective Date December 26, 2000 Page 23
SETUP, STARTUP, ADJUSTMENT, OPERATION and SHUTDOWN
4. Angle Cuts:
Angle Cuts may be performed using the Step Cut, Chop Cut or the Locked Cutting Head cutting methods.
The following is utilizing the Locked Cutting Head method.
DO NOT FORCE TOOL, it will do the job better and safer at the rate for which it was designed.
NOTE: Care must be used when cutting angles so as not to damage the Adjustable Cutting Guide.
Skip steps F and G, if cutting dry.
(B)
Reposition Adjustable
Cutting Guide
(A)
Remove Adjustable
Cutting Guide
(C)
Position masonry piece
against the Adjustable
Cutting Guide
(F)
Open the Cooling Flow Control
Valve and adjust flow
(E)
Position Adjustable Cutting
Guide and masonry piece to
required cut position
(D)
Lock Cutting Head in
the down position
(H)
Move the Throttle Lever to
adjust blade speed (faster blade
speed for smoother cuts)
(G)
Verify cooling flow exists on
both sides of the blade
(I)
Setup to Cut
Remove Adjustable
Cutting Guide
Align 45 ° Slots
to Ruler/Stop
Ruler/Stop
Place Work
in Position
Adjustable
Cutting Guide
Lock Cutting
Head in down
position
Loosen Locking
Handle to adjust
Cutting Head
Align work
with Blade
Turn clockwise
to tighten
Direction of
Movement
Control Valve
Direction of
Movement
Hold Work
in Position Cooling Flow
Points Throttle Lever
Turn counterclockwise
to loosen