MK Diamond MK-2005G - Manual (Page 42)

MK-2005G Revision 12/00, Effective Date December 26, 2000 Page 42
MAINTENANCE AND TROUBLESHOOTING
NOTE: DO NOT use a screwdriver when installing new belts.
(M)
Remove the V-belt
(L)
Push the Engine Mounting Plate
toward the front of the unit to
loosen the V-belt
(K)
Loosen Engine Adjustment
Strap Lock-nut then loosen
the Engine Adjustment Strap
(J)
Loosen engine mounting plate
If re-tensioning, go to step S
(O)
Verify the V-belt is seated in
The grooves of both pulleys
(N)
Install the new V-belt
(MK Diamond Part No. 156294)
(P)
Verify the Engine Adjustment
Strap Lock-nut is loose then
tighten the Adjustment Strap
(R)
Check V-belt tension
(proper tension 1/8-inch)
(Q)
Tighten the Engine Adjustment
Strap to remove slack
(S)
Continue adjusting V-belt until
tension is correct then tighten the
Engine Adjustment Strap Lock-nut
(U)
Install the Belt Guard
(T)
Check V-belt tension
(proper tension 1/8-inch)
Turn counter-
clockwise to
loosen
1/2-inch
Wrench
Retaining Bolts
1/2-inch
Wrench
Adjustment
Strap Bolt
V-belt V-belt Pulley
Turn clockwise
to tighten
1/2-inch
Wrench
Remove Slack
Check Tension
1/2-way
between pulleys
Check Tension
1/2-way
between pulleys
Turn clockwise
to tighten
1/2-inch
Wrench
1/2-inch
Wrench
Retaining Bolts Turn clockwise
to tighten
Turn counter-
clockwise to
loosen Direction of Push