MTS Series 793 - Manual (Page 17)

MTS Series 793 Tuning and Calibration Introduction 17
Chapter 1
Introduction
This manual describes how to perform servovalve adjustments, tune, and
calibrate all MTS 793 Controllers.
Note TestStar IIs, TestStar II AP, and FlexTest II CTM Controllers are not
equipped with this manual. The equivalent information is located in the
associated service manual (PDF) on the 793 Installation CD.
This chapter describes how individual tuning and calibration controls work in
general—that is, their principals of operation.
Where to find control
descriptions for specific
controller models
For a description of specific tuning and calibration controls (as displayed in the
MTS 793 control software user interface) for FlexTest IIm, automated FlexTest
SE, FlexTest GT, and TestStar IIm Controllers, see the MTS 793 Control Software
manual.
For a description of the specific tuning and calibration controls displayed on the
front panel of stand-alone FlexTest SE Controllers, see the FlexTest SE Users
manual.