MTS TW Elite - Manual (Page 125)

MTS TestSuite TW Behavior TestWorks 4 Behavior Function
status. Instead, the names of test runs
that have not been run are italicized. not been started was hollow, and it was filled
in when the test run completed.
When the test run completes, the text
becomes normal (non-italics).
When using HD control modes in
TWE, the outer-loop control mode is If you use advanced rate control in TW4, the
outer-loop control mode is not maintained
Outer Loop
Control Modes
maintained when transitioning when transitioning from a GoTo activity to
another activity in a test.
between GoTo activities in a test.
However, similarly to TW4, the
crosshead control mode will become
the active control mode if an interlock
occurs. This behavior prevents the
crosshead from moving suddenly after
resetting an interlock.
For More Information
Conversion Issues for MTS FlexTest Controllers (p. 125)
Converting TestWorks 4 Methods and Sample
Files
Quick access:
Start menu > All Programs > MTS TestSuite > TestWorks 4 Converter
The TestWorks 4 Converter allows you to convert TestWorks 4 methods and sample files, or entire folders,
so they can be used with the MTS TestSuite TW application.
There are differences in file formats and pre-set parameters (such as safety parameters) between the two
programs, therefore, you must review each converted template or test to confirm the accuracy of the
conversion. Although the intent of the converter is to provide a completely converted file, MTS does not
guarantee that it can or will permit complete conversion of your TestWorks 4 method or sample file into
an MTS TestSuite TW template or test.
Conversion Issues for MTS FlexTest Controllers
The TestWorks 4 application has the capability to apply calculations to FlexTest Controller signals. The
TW application does not have this capability.
MTS TestSuite | 125
TW Elite for TestWorks 4 Users