5 verify operation, Verify operation, Page 25 – Omnitron Systems Technology Converter GXTM User Manual User Manual
Page 25
3.5
VERIFY OPERATION
PI
SA
Once the module has been installed and configured, per Sections 3.2 - 3.4, verify the module is operational
by viewing the status of the LED indicators. The table below provides a description for each LED indicator.
The Power LED indicates the module is receiving power from the chassis or power cord. The plug-in
modules has an LED indicator for each available power supply in the chassis (the 19-Module Chassis has
three, the 5-Module Chassis has two).
The Fiber Optic “FO” LED indicates the fiber optic connection between the modules has been established.
A blinking LED indicates the presence of data.
The UTP LEDs indicate the module has established a connection across its UTP port. A blinking LED
indicates the presence of data. See both tables to determine the UTP connection speed.
Refer to Section 6.0, Troubleshooting Guide, for help in determining possible fault conditions.
PI
SA
PI
SA
LED Function
"Legend"
Color
Off State
On / Blinking State
On / Blinking State
Power "Pwr"
Amber No power
On: Module has power
On: Module has power
Power Supply
Status # X
Amber
Chassis Power
Supply not installed
On: Power available from
installed Power Supply # X.
Blinking: No power available
from installed Power Supply # X
Not available on standalone
1000Mbps
Fiber Optics
"FO"
Green
No Fiber Link
On: Fiber Link
Blinking: Fiber Data Activity
On: Fiber Link
Blinking: Fiber Data Activity
Chassis
Management
Master/Slave
"Msr/Slv"
Green
Chassis in Slave
Mode
On: Chassis Master Mode
Blinking: Operating in OAM
Mode
Not available on standalone
UTP port
100Mbps
"100"
Green
Not linked at
100Mbps
On: UTP linked at 100Mbps
Blinking: UTP Data Activity
On: UTP linked at 100Mbps
Blinking: UTP Data Activity
UTP port
1000Mbps
"1000"
Green
Not linked at
1000Mbps
On: UTP linked at 1000Mbps
Blinking: UTP Data Activity
On: UTP linked at 1000Mbps
Blinking: UTP Data Activity
UTP port
10Mbps
"100" + "1000"
Green
Not linked at
10Mbps
On: UTP linked at 10Mbps
Blinking: UTP Data Activity
On: UTP linked at 10Mbps
Blinking: UTP Data Activity
UTP port
Full-Duplex
"FDX"
Green
Half-Duplex when
any UTP link is
active
On: Full-Duplex when any UTP
link is active
On: Full-Duplex when any UTP link
is active
Note: On some models the fiber optic LED is referred to as ‘P1’.
LED Legend/State
UTP Link Speed
"1000"
"100"
OFF
OFF
UTP Not Linked
OFF
ON
UTP Linked at 100Mbps
ON
OFF
UTP Linked at 1000Mbps
ON
ON
UTP Linked at 10Mbps
Page 25