MacDon M155 Operators Manual User Manual
Page 138
Before driving windrower on a roadway:
1. Ensure HEADER DRIVE switch (A) is pushed to OFF
position (down).
2. Clean flashing amber lamps, red tail lamp and head
lamps, and check that they work properly.
3. Clean all reflective surfaces and slow moving
vehicle emblems.
4. Adjust interior rear view mirror and clean windows.
Figure 4.32: Header Drive Switch
5. Push LIGHT switch (A) to ROAD position to activate
lamps. Always use these lamps on roads to provide
warning to other vehicles.
a. Use HIGH / LOW LIGHTS (B) as required when
other vehicles are approaching.
b. Do NOT use FIELD lamps on roads, other drivers
may be confused by them.
6. Push BEACON switch (C) ON to activate beacons .
Figure 4.33: Light Switches
7. Press switch (A) on cab display module (CDM) to
activate hazard lights.
Figure 4.34: CDM
169883
122
Revision A