Return filter, Removing return filter, Installing return filter – MacDon M155 Operators Manual User Manual
Page 380
Return Filter
The return filter filters the oil in the header drive systems and should be changed after the first 50 hours and
then at 500 hour intervals.
To change the return filter, refer to the following procedures:
•
Removing Return Filter, page 364
•
Installing Return Filter, page 364
Removing Return Filter
1. Stop the engine and remove the key.
2. Clean around head of the filter (A).
3. Place a container beneath the filter (A) to collect any
oil that may leak out.
4. Unscrew filter (A) with a filter wrench.
5. Dispose of used oil and filter in accordance with local
environmental legislation.
Figure 5.199: Hydraulic System
NOTE:
Image showing filter head removed to show
component clarity.
6. Remove gasket (C) from groove (B) in filter head (A).
Figure 5.200: Hydraulic System
Installing Return Filter
NOTE:
For filter specifications, refer to
.
169883
364
Revision A