MacDon M155 Operators Manual - Manual (Page 255)

OPERATION
2. Using HEADER TILT SWITCHES (A) and (B) on the
GSL, set center-link to mid-range position (05.0 on
DISPLAY [E]).
3. Push DECK SHIFT switch (G) on the console to
desired delivery position.
4. Using HEADER DOWN switch (C) on the GSL, lower
header fully with lift cylinders fully retracted.
5. Using LEFT FLOAT SWITCH (D), push + to increase
float or – to decrease float on left side of header.
DISPLAY (E) will indicate selected float for left side,
for example (8.0 L FLOAT R ##.#).
6. Repeat for right side float with RIGHT switch (F).
DISPLAY (E) will indicate float for both sides, for
example (8.0 L FLOAT R 3.0). Figure 4.291: Operator Console
A - Header Tilt Down B - Header Tilt Up
C - Header Down D - Left Float
E - Display F - Right Float
7. Select a second deck position with the DECK SHIFT
switch (G).
8. Repeat steps 5. and 6. above to set the float.
9. Select a third position if desired with the DECK SHIFT
switch (G) and repeat steps 5. and 6. above to set
the float.
Figure 4.292: Deck Shift Switch
A - Deck Shift Switch B - Left Side Delivery
C - Center Delivery D - Right Side Delivery
169883
239
Revision A