MacDon M155 Operators Manual - Manual (Page 299)

MAINTENANCE AND SERVICING
5. Adjust switch (A) as follows:
a. Loosen nuts (B) and rotate switch on support
sufficiently so that GSL will contact switch lever (C)
and push in the plunger (D).
b. Tighten nuts (B).
Figure 5.41: Switch Lever
6. If necessary, replace switch as follows
a. Disconnect wiring harness (A) at connector.
b. Remove nuts and screws (B) and remove
switch (C).
c. Install new switch (C) on support and secure with
nuts and screws (B).
d. Connect harness (A) to console wiring.
Figure 5.42: GSL Switch Lever
7. Position switch support plate (B) inside console and
secure with rubber nuts (A).
NOTE: For clarity, console in the image was made
transparent to show the switch support plate (B).
8. Check operation of switch.
Figure 5.43: Console (Transparent)
169883
283
Revision A