MacDon M155 Operators Manual - Manual (Page 360)

MAINTENANCE AND SERVICING
3. Remove grommet (A) from light support (B).
4. If replacing lamp and bracket assembly, remove nut (C)
and spring washer from inside light support (B) and
remove light assembly.
Figure 5.159: HID Light Assembly
5. If replacing the lamp only, remove the nut, spring
washer and bolt (A) securing lamp (B) to lamp
bracket (C) and remove lamp (B).
6. If installing lamp only, position new lamp (B) in lamp
bracket (C) and secure with bolt (A), spring washer and
nut. Adjust lamp (B) to desired position and tighten
bolt (A).
Figure 5.160: HID Auxiliary Lights
7. If installing light/bracket assembly, locate light in center
hole in light support (B) and secure with hardware (C)
provided with light assembly. Adjust light assembly to
desired position and tighten nut (C).
8. Route lamp harness through grommet (A) and slot in
light support (B).
9. Reinstall grommet (A) in light support (B).
Figure 5.161: HID Light Assembly
169883
344
Revision A