MacDon M155 Operators Manual - Manual (Page 260)

OPERATION
Figure 4.296: Operator Console
A - Display B - Header Index C - Fast
D - Slow E - Display Selector
IMPORTANT:
Windrower can be moving, but must be less than minimum reel speed.
1. Set the Minimum Reel Speed as follows:
a. Engage header.
b. Set HEADER INDEX switch (B) to ON.
c. On ground speed lever (GSL) press DISPLAY SELECTOR (E) to display ##.## MIN REEL, or press FAST (C)
or SLOW (D) switch.
##.## = RPM or MPH or KPH
19
d. Press SLOW (D) until beep is heard.
e. Display (A) shows ##.## REEL MIN RPM.
NOTE: The reel will continue operating at the Minimum Reel Speed setting when ground speed drops below this
value. DISPLAY (A) will flash ##.## MIN REEL (RPM or MPH or KPH
19 ) to prompt the operator to change
the minimum set-point, or increase ground speed if Ground Speed Plus Index is LESS THAN the Minimum
Reel Speed Set-Point.
2. Set the Reel Index as follows:
IMPORTANT:
Windrower can be moving, but must be greater than minimum reel speed.
a. Set HEADER INDEX switch (B) to ON.
19. As per settings in cab display module (CDM) programming.
169883
244
Revision A