MacDon D60 Draper Headers - Manual (Page 26)

SECTION 7. OPERATION
Form 169441 24 Revision B
b. Connect reel hydraulics (E) as follows:
1. Check connectors, and clean if required.
2. Open cover (F) on header receptacle.
3. Push in lock button (G), and pull handle (H)
to “half open” position.
4. Remove hose bundle with multi-coupler (E)
from tractor, position onto header receptacle,
and push handle (H) to engage pins on
connector.
5. Push handle away from hoses until lock
button (G) snaps out.
c. Raise and lower header and reel a few times to
allow trapped air to pass back to the reservoir.
7.3.2 DETACHMENT
a. Fully lower the reel.
b. Disconnect the reel hydraulics as follows:
1. Push in lock button (G), and pull handle (H)
to disengage multi-coupler (E) from header
receptacle.
2. Route hose bundle back onto windrower, and
store multi-coupler (E) on hose support.
3. Close cover (F) on header receptacle.
(shown in previous column)
(continued next page)
F
G
H
G
H
E
E
E