MacDon D60 Draper Headers - Manual (Page 36)

SECTION 7. OPERATION
Form 169441 34 Revision B
7.12 HEADER OPERATING VARIABLES
Satisfactory function of the header in all situations
requires making proper adjustments to suit
various crops and conditions.
Correct operation reduces crop loss, and allows
cutting of more acres. As well, proper
adjustments and timely maintenance will increase
the length of service you receive from the
machine.
The variables listed below and detailed on the
following pages will affect the performance of the
machine. You will quickly become adept at
adjusting the machine to give you the desired
results.
VARIABLE SECTION
Cutting Height 7.12.1
Header Float 7.12.2
Header Angle 7.12.3
Reel Speed 7.12.4
Ground Speed 7.12.5
Draper Speed 7.12.6
Knife Speed 7.12.7
Reel Height 7.12.8
Reel Fore-Aft Position 7.12.9
Reel Tine Pitch 7.12.10
Crop Dividers and Rods
7.12.11
7.12.1 CUTTING HEIGHT
The D Series of draper headers are designed to
allow an Operator to cut the crop above the
ground for a desired stubble height, or to cut the
crop at ground level with the header on the
ground.
Cutting height will vary, depending on type of
crop, crop condition, etc. Refer to Section 7.11
HEADER SET-UP.
7.12.1.1 Cutting Off The Ground
Cutting height is controlled with a combination of
header lift cylinder adjustment and a stabilizer
wheel system or a stabilizer/slow speed transport
wheel system.
The stabilizing wheel system in both options is
designed to minimize bouncing at the header
ends and may be used to “float” the headers to
achieve an even cutting height when cutting
above ground level in cereal grains. The system
can provide very even stubble height and greatly
reduced Operator fatigue. Both systems are only
available on 30, 35, and 40 FT. headers.
The proper setting requires ‘balancing’ the
amount of header weight carried by the Float and
the stabilizer wheels.
CAUTION
Stop engine, and remove key from ignition
before leaving Operator's seat for any reason.
A child or even a pet could engage an idling
machine.
a. Raise the header so that the stabilizer wheels are
off the ground. Shutdown engine and remove the
key.
b. Check that the Float is working properly. See
Section 7.12.2 Header Float.
c. Set up the stabilizer wheels, if installed, as
follows: Otherwise, proceed to step d.
IMPORTANT
Do not use the stabilizer wheel system
for header height control if your header
was manufactured prior to 2007. This
would result in damage to the wheel
suspension system.
CAUTION
Handle may be under tension, especially
when the wheels are on the ground. Raise
header so that wheels are off the ground
before making adjustments.
1. Support wheel weight by lifting slightly with
one hand. Pull “up” on handle (A) to release
lock.
2. Lift wheel with handle (B) to and engage
support channel into center slot (C) in upper
support.
3. Push “down” on handle (A) to lock.
(continued next page)
LH SHOWN - RH OPPOSITE
A
C
B