MacDon D60 Draper Headers - Manual (Page 31)

SECTION 7. OPERATION
Form 169441 29 Revision B
7.10 REEL PROPS
WARNING
To avoid bodily injury from fall of raised reel,
always engage reel props before going under
raised reel for any reason.
IMPORTANT:
To prevent damage to reel support
arms, do not transport header with reel
props engaged.
Reel props are located at each reel support arm.
To engage reel props, proceed as follows:
D60 Header:
a. Raise reel to maximum height.
b. Move props (A) to engaged position.
NOTE
Keep pivot bolt (B) properly tightened
so prop remains in stored position when
not in use, yet can be engaged with
hand force.
c. At the center reel arm on split reel headers, move
lock (C) to inboard position to engage pin (D)
under prop.
d. Lower reel until props contact end frames.
e. To disengage reel props, raise reel, push outside
arm props (A) back against reel arm.
f. For split reel headers, move lock (C) to outboard
position.
D50 Header
a. Raise reel to maximum height.
b. Move props (A) to engaged position.
c. Lower reel until props contact end frames.
NOTE
Keep pivot bolt (B) properly tightened
so prop remains in stored position when
not in use, yet can be engaged with
hand force.
d. To disengage reel props, raise reel, push outside
arm props (A) back against reel arm.
B
A
D60
B
A
D60 HARVEST HEADER
C
D