MacDon D60 Draper Headers - Manual (Page 82)

SECTION 8. MAINTENANCE AND SERVICING
Form 169441 80 Revision B
SAMPLE GREASE DECAL
e. To achieve a snug fit between the aft end of the
shield and header frame, loosen bolts (F), and
adjust the latch (G) to re-position the shield.
f. Tighten bolts (F).
8.5 LUBRICATION
CAUTION
To avoid personal injury, before servicing
header or opening drive covers, follow
procedures in Section 8.1 PREPARATION
FOR SERVICING.
Refer to Section 8.3.4 Recommended Fluids and
Lubricants for recommended greases.
The greasing points are marked on the machine
by decals showing a grease gun (A), and grease
interval (B) in hours of operation.
Log hours of operation, and use the
"Maintenance Checklist" provided to keep a
record of scheduled maintenance.
Refer to Section 8.11 MAINTENANCE
SCHEDULE.
8.5.1 GREASING PROCEDURE
a. Wipe grease fitting with a clean cloth before
greasing, to avoid injecting dirt and grit.
b. Inject grease through fitting with grease gun until
grease overflows fitting, except where noted.
c. Leave excess grease on fitting to keep out dirt.
d. Replace any loose or broken fittings immediately.
e. If fitting will not take grease, remove and clean
thoroughly. Also clean lubricant passageway.
Replace fitting if necessary.
8.5.2 LUBRICATION POINTS
Refer to the illustrations on the following pages to
identify the various locations that require
lubrication.
F
G