MacDon D60 Draper Headers - Manual (Page 80)

SECTION 8. MAINTENANCE AND SERVICING
Form 169441 78 Revision B
d. Adjust the endshield to achieve the gap ‘X’
between the front end of the shield and the
header frame, in accordance with this chart.
TEMPERATURE
Degrees ˚F (˚C)
GAP ‘X’
Inches (mm)
25 (- 4) 1.1 (28)
45 (7) 1.0 (24)
65 (18) 0.79 (20)
85 (29) 0.64 (16)
105 (41) 0.5 (12)
125 (52) 0.32 (8)
145 (63) 0.16 (4)
165 (89) 0
e. Tighten bolts (D) and (E) (shown on previous
page).
f. To achieve a snug fit between the aft end of the
shield and header frame, loosen bolts (G), and
adjust the latch (H) to re-position the shield.
g. Loosen bolts (J) on endshield support, and adjust
endshield to align with endsheet, as shown
above.
h. Tighten bolts (G) and (J).
i. Close endshield.
8.4.1.2 Removal
a. Open endshield.
b. Remove screw (K) at top of support tube.
c. Lift endshield off support tube.
K
H
G
J X