MacDon D60 Draper Headers User Manual
Page 48
SECTION 7. OPERATION
Form 169441
46
Revision B
NOTE
Loosen a hose fitting to allow
movement of cylinder rod. Be sure to
re-tighten fitting after cylinder
installation.
4. Re-install plates (M) and (O) with bolts (L)
and (N) respectively.
d. Re-position
right
arm
cylinder (Single Reel) as
follows:
1. Remove bolt, and nut (Q), four bolts (R)
securing hose shield (S).
2. Move hose shield and hoses away from
cylinder.
3. Remove bolts (T) that secure aft plate (U),
and remove the plate.
4. Remove bolts (V) so that front support (W) is
free to move up.
5. Lift the aft end of the cylinder out of support
assembly, and retract the cylinder so that
cylinder center port fitting (X) engages the
support assembly.
NOTE
Loosen a hose fitting to allow
movement of cylinder rod. Be sure to
re-tighten fitting after cylinder
installation.
6. Re-install plates (U) and (W) with previously
removed bolts (T) and (V) respectively.
7. Re-position hoses, and re-install shield (S)
with bolts (R).
8. Position hoses inside shield, and install bolt
and nut (Q).
(continued next page)
X
W
U
Q
S
R
U
T
RIGHT ARM - SINGLE REEL
RIGHT ARM - SINGLE REEL
W
V
Q
S
R
U
T
RIGHT ARM - SINGLE REEL