MacDon R85 Rotary Disc 16 Foot Self-Propelled Windrower Headers - Manual (Page 165)

MAINTENANCE AND SERVICING
7.9 Electrical
Use electrical tape and wire clips as required to prevent wires from dragging or rubbing.
Keep lights clean and replace defective bulbs.
DANGER
Stop engine and remove key from ignition before leaving operator’s seat for any reason. A child or even
a pet could engage an idling machine.
7.9.1 Hazard Lights
Hazard Lights: Replacing Bulbs and Lenses
Follow these steps to replace a hazard light bulb or lens:
1. Using a Phillips screwdriver, remove screws (A) from
fixture and remove plastic lens (B).
2. Replace bulb and reinstall plastic lens and screws.
NOTE: See parts catalog for bulb part number.
Figure 7.75
Hazard Lights: Replacing the Lamp Assembly
Follow these steps to replace the lamp assembly:
1. Remove four bolts (A) and nuts, and remove lamp
assembly (B) from lamp bracket (C).
2. Disconnect lamp wires from wiring harness at
connectors (D).
3. Connect new lamp wires to wiring harness (D).
4. Place lamp assembly (B) on lamp bracket (C) and
secure with four bolts (A) and nuts.
Figure 7.76
169457
157
Rev. F