MacDon R85 Rotary Disc 16 Foot Self-Propelled Windrower Headers - Manual (Page 95)

OPERATING THE HEADER
6.10.3 Returning Tall Crop Feed Plates to Storage
Follow these steps to install the tall crop feed plates:
DANGER
Stop engine and remove key from ignition before
leaving operator’s seat for any reason. A child or
even a pet could engage an idling machine.
1. Lower the header fully.
2. Shut off the engine and remove the key.
3. Open the RH end drive cover. See Section 5.4.3
Removing Right End Shield: North American Headers,
page 29
.
4. Remove nuts (A) and secure the feed plates (B) to side
of compartment and remove plates. Reinstall nuts (A).
5. Install RH shield. See Section 5.4.4 Installing Right
End Shield: North American Headers, page 29 .
Figure 6.31
169457
87
Rev. F