MacDon PW7 Pick-Up Header - Manual (Page 19)

SECTION 3
SETUP COMPLETION
Form 169149 Revision E 13
3.1 CONNECTING HEADER/PICKUP TO
COMBINE: JOHN DEERE / LEXION/
AGCO
NOTE: For Case IH and New Holland
Combines, see Section 3.2
NOTE: The operator of the combine should
be well trained in the use of combine controls.
Improper use of the combine could result in
damage to property or serious injury or
death.
a) Check to see that all header and feeder house
locking devices are open and ready for
engagement.
b) On combines equipped with feeder house
lateral tilt, position the feeder house front
face to be square with feeder house floor.
c) Lower the combine feeder house so that the
feeder house saddle will just pass under the
upper beam of the header.
d) Enter the header opening and lift the header
off the ground. The feeder house saddle and
header beam should now be firmly engaged.
e) Raise the feeder house completely.
f) TURN OFF COMBINE ENGINE,
REMOVE THE KEY FROM THE
IGNITION, AND ENGAGE THE
FEEDER HOUSE SAFETY LOCK.
Positioning on Combine
(May not be exactly as shown)
Engaged Feeder House Lock
(May not be exactly as shown)
g) Engage the header locking mechanisms,
wiring and hydraulics. Refer to the
“Completing Hook Up to Your Combine”
section for combine specific instructions.
h) Attach auger drive shaft. See “Drive Shaft
Installation”-section 7.5 in this manual.
i) Disengage the feeder house locks and secure
in the storage position.
P00030
FEEDER SADDLE
HEADER UPPER BEAM
P00029