MacDon PW7 Pick-Up Header - Manual (Page 60)

SECTION 7 – SERVICE
Form 169149 Revision E 54
NOTE: The hose on the motor port closest to
the header is the supply line and the hose
furthest from the header is the return line.
Identification of the header lines is as follows:
 Lower 3/8 inch line is the hydraulic
hold down line
 Middle line is the motor return line
 Upper line is the supply line
NOTE: Hold down hose must have sufficient
slack and be oriented properly to prevent
damage.
Rake-Up Orientation
SwathMaster Orientation
c) All steel lines are firmly mounted to the
header wall with clamps.
Hose Clamping
JOHN DEERE 60 SERIES MODELS
Hydraulic/Electrical Connection
Orientation of Hydraulic Lines
A. Coupler Removal and Installation:
1) Remove snap ring.
2) Remove coupler.
3) Remove coupler fitting.
4) Install coupler fitting into new coupler.
5) Place coupler into the socket and
replace snap ring.
Supply
Return
Return
Hold down
Return
Supply
P00582R
P00581
P00585
P00493R
Return
Supply
Return
P00695
Supply
Supply
Hold down
Hold down