MacDon PW7 Pick-Up Header - Manual (Page 20)

SECTION 3 – SETUP COMPLETION
Form 169149 Revision E 14
Disengaged Feeder House Lock
(May not be exactly as shown)
Completing Hook Up To Your Combine
Each combine manufacturer has a different
design for lower locking mechanism on the
header. The locking mechanism is an important
step in protecting your header/pickup from
damage.
On all models the feeder house must be properly
installed onto the header before the locks could
be activated.
ATTENTION : Do not operate or move
header without engaging the lower locking
mechanism. Failure to do so may cause
damage to your equipment.
3.1.1 JOHN DEERE
50 Series:
a) Take the John Deere locking pin out of its
storage position and slide it into the slot of
the header.
b) Loosen the nuts of the header locking plates.
c) Position the plate so that the lower corner of
the plate rests against the pin.
d) Check that pin moves freely in and out.
e) Tighten the header adjustment plate nuts.
f) Modification to hydraulic lines and wiring
harnesses may be required if adapter kit is
not available from local dealer.
John Deere Locked Position
50 Series Open Position
60 Series:
60 Series combines come equipped with a multi
function system, which connects the hydraulics,
electrical and mechanical locks.
a) Remove the hydraulic multi coupler from the
storage bracket.
b) Install the multi coupler onto the feeder
house coupler.
P00032
P00033
HEADER
ADJUSTMENT
PLATE
P00009