MacDon PW7 Pick-Up Header User Manual
Page 25
SECTION 3 – SETUP COMPLETION
Form 169149
Revision E
19
FEEDER SADDLE
HEADER UPPER BEAM
B
A
3.2 CONNECTING HEADER/PICKUP TO
COMBINE – CASE IH &
NEW HOLLAND
NOTE: The operator of the combine should
be well trained in the use of combine controls.
Improper use of the combine could result in
damage to property or serious injury or
death.
NOTE: For New Holland combines built prior
to Model Year 2009, order B5614 – NH Auto
Header Height Sensor Kit from your MacDon
Dealer. Installation instructions are provided
with the kit.
a) Check to see that all header and feeder house
locking devices are open and ready for
engagement. Ensure handle (A) is positioned
so that hooks (B) can engage header lower
mounts.
b) On combines equipped with feeder house
lateral tilt, position the feeder house front
face to be square with feeder house floor.
c) Lower the combine feeder house so that the
feeder house saddle will just pass under the
upper beam of the header
d) Enter the header opening and lift the header
off the ground. The feeder house saddle and
header beam should now be firmly engaged.
Positioning on Combine
(May not be exactly as shown)
e) Raise the feeder house completely.
f) TURN OFF COMBINE ENGINE,
REMOVE THE KEY FROM THE
IGNITION, AND ENGAGE THE
FEEDER HOUSE SAFETY LOCK.
Engaged Feeder House Lock
(May not be exactly as shown)
P00029
P00030