MacDon PW7 Pick-Up Header - Manual (Page 52)

SECTION 7
SERVICE
Form 169149 Revision E 46
7.1 ATTACHING PICKUP TO HEADER
DANGER : Lower header to the
ground or engage feeder house
locks, shut-off combine, remove
ignition key, and wait for parts to stop moving
before servicing.
ATTENTION : Do not lift the header
without the header braces properly installed.
Attempting to lift the header without header
braces will damage the pick up or header.
Parts damaged due to improper handling are
not covered by warranty.
Positioning on Header
a) Support the pickup with the rear roller at
approximately 14 inches (356mm) above the
ground with wooden blocks located under the
shock tubes. See following drawings.
Installing Rake-Up onto the Header
Installing SwathMaster onto the Header
13 FT. HEADER: With the header mounted
on the combine, position the header cutter bar
under the pick up mounting bracket for 12ft
pickups and above the mounting bracket for
14ft pick ups.
Position the header such that the left and right
hand channel uprights on the pickup frame are
equal distances from the sides of the header.
On 14ft pick ups, the channel uprights are
outside the header.
See illustrations next page.
D00332
D00333A