MacDon PW7 Pick-Up Header - Manual (Page 24)

SECTION 3 – SETUP COMPLETION
Form 169149 Revision E 18
A
B
C
b) Attach hydraulics and electrical - Single
Point Connection (if equipped):
Clean all hydraulic hoses and couplings
before connecting to prevent contamination of
hydraulic system.
Align the single point header connector (A)
with the single point connector on the
combine (B) and lock by moving latch (C)
over-center.
NOTE: To install a header with single point
connector on a combine without a single point
connector, an adapter is required. See your
combine dealer.
Agco Single Point Connector – Header Side
Agco Single Point Connector – Combine Side
d) Connect hydraulic hoses to combine –
Without Single Point Connection:
Attach the ½ inch hydraulic hose from
the combine to the female coupler on the
header.
Attach the ½ inch hydraulic hose from
the header to the female coupler on the
combine.
Attach the 3/8 hydraulic hose (hold-down
line) from the header to the combine.
Agco Hydraulic Connections
(Non Single Point Connector)
e) Connect wiring harness – Without Single
Point Connection:
Attach extremity lighting wiring harness
to the combine receptacle, located on the
left side of the feeder house. Ensure
harness connector is pushed in far enough
to lock into receptacle.
Agco Electrical Connections
(Non Single Point Connector)