MacDon PW7 Pick-Up Header - Manual (Page 55)

SECTION 7 – SERVICE
Form 169149 Revision E 49
7.3 REMOVING PICKUP SHIELDS
SWATHMASTER
Removal:
a) Unscrew the upper and side
thumbscrews.
b) Grabbing hold of the upper ridge,
pull off the Shield.
Installation:
a) Position the shield onto the brackets
and slide back and forth until circular
indentation falls into the rear guide.
b) Tighten the thumbscrews.
RAKE-UP
Remove four 5/16” bolts and pertaining
hardware.
Rake-Up Drive Shield Removal
7.4 HYDRAULIC
SYSTEM
CAUTION : High-pressure
hydraulic oil can cause serious
injuries such as burns, cuts, and
tissue damage! Always take
precautions when working with hydraulic oil.
Wear safety goggles, gloves and thick
clothing. Seek immediate medical attention if
cut or burnt.
ATTENTION : On some combine models,
hydraulically driven after-market chaff
spreaders are connected to the pickup drive
hydraulic pump. When the pickup is sharing
the drive with a chaff spreader, the pickup
performance can be adversely affected or
damage may occur to the hydraulic system. If
the hydraulic motor on the pickup is mounted
in series in front of the chaff spreader,
backpressure from the chaff spreader may
cause damage to the pickup motor. The
pickup motor warranty is voided under these
conditions.
Thumbscrews
Upper Ridge
Rear Guide
P00700
P00689
P00688