MacDon PW7 Pick-Up Header - Manual (Page 26)

SECTION 3 – SETUP COMPLETION
Form 169149 Revision E 20
G
E
A
B
H
H
J
K
g) Push up on handle (A) on combine so that
hooks (B) from photo on page 2 engage
header lower mounting pins (K) on both
sides of the feeder house.
h) Be sure slot in lever (E) engages welded rod
on handle (A) to lock handle in place.
i) If hook (B) does not fully engage header
lower mounting pin (K) on both sides of the
feeder house when (A) and (E) are engaged,
adjust position of mounting pin (K) in slot as
required.
If force to engage handle (A) and lever (E) is
too loose or excessive, loosen bolts (G), and
adjust lock force as required. Re-tighten
bolts.
j) Connect Hydraulic Multi-coupler at (H) and
electrical harness at (J).
k) Disengage the feeder house locks and secure
in the storage position.
Disengaged Feeder House Lock
(May not be exactly as shown)