MacDon PW7 Pick-Up Header - Manual (Page 54)

SECTION 7 – SERVICE
Form 169149 Revision E 48
D
E
F
7.2 OPENING HEADER SIDE PANELS
John Deere / Lexion / Agco:
To remove left panel, unscrew bolts and lift up
on panel.
Left Hand Shield: John Deere / Lexion / Agco
To remove right panel unscrew bolts and pull
away from header.
Right Hand Shield: John Deere/Lexion/Agco
NOTE: It is not necessary to remove panels
to perform adjustments on units. See 4.11
Header Drive Chain Adjustment.
Case IH / New Holland:
a) To open shield, push release tab (D) towards
rear of machine. Latch will release top of
shield.
b) Swing shield down and away from machine
to allow enough room to lift it. Lift shield
enough to disengage lower hooks and
remove the shield.
c) To close shield, engage shield hooks (E) in
slots at bottom of frame.
d) Swing shield up to engage upper tab latch
mechanism (F).
e) Close side panel until it is securely latched.
P00551
P00552