MacDon PW7 Pick-Up Header - Manual (Page 67)

SECTION 7 – SERVICE
Form 169149 Revision E 61
Header Drive Chain
Sprocket Details
NOTE: The shim quantity and placement
may not be as shown. Take note to ensure
proper orientation of shims if removal is
necessary.
NOTE: Chain tension must be checked and
adjusted after the first 3 hours of
operation, and at regular intervals.
7.7 REPLACING AUGER FINGERS
WARNING: DO NOT attempt
any service procedure until
combine is lowered to the ground
or feeder house locks are engaged,
combine is shut off, the key is
removed and all moving parts have
stopped.
The following procedure will guide you in the
removal/installation process of an auger finger:
a) Disconnect drive shaft from combine and
place it on the storage bracket.
b) Remove the M6 Hex Head Bolt on the hand
hole cover closest to the finger (s) being
serviced.
c) Rotate the auger by hand until the damaged
finger is placed in the most convenient
position.
d) Remove the finger holder hitch pin.
e) Remove old finger and replace with new one.
NOTE: The new finger will have to be
inserted through the hand hole cover and
through the finger guide.
f) Install hitch pin in same position as it was
before servicing to prevent interference.
g) Install hand hole cover and the bolts.
Auger Finger Replacement
D00328
P00498
P00085