MacDon PW7 Pick-Up Header - Manual (Page 45)

SECTION 5 – OPERATING INSTRUCTIONS
Form 169149 Revision E 39
electrical wiring and feeder house locks
simultaneously. The coupler is to be
unlocked and stored in the storage
bracket. Other models have a coupler
system for the hydraulics and separate
electrical harness connections.
f) Remove the drive shaft from the feeder
house and place it on the storage bracket.
g) Engage the feeder house lock.
h) Unlock the lower hookup points on
header.
i) Disengage the feeder house lock.
j) Lower the feeder and slowly drive out of
the feeder house opening of the header.
5.6 UNPLUGGING THE AUGER
Occasionally the auger may become plugged
and will require unplugging.
To unplug feeder house or auger with
combine reverser:
a) Refer to your combine manual for
operating instructions.
b) Stop combine forward travel.
c) Shut off pickup unit.
d) Raise hold down all the way up.
e) Engage reverse mode.
NOTE: To prevent damage to the pickup
motor, DO NOT engage the feeder reverser
for more than 5 seconds if the feeder and
auger will not turn.
ATTENTION : Pickups cannot run in
reverse. Any attempt to run pick up in
reverse will seriously damage pick up
and/or pick up motor.