MacDon Double Windrow Attachment - Manual (Page 19)

SECTION UA – UNLOADING AND SETUP
Form 169365
UA-5
Issue – May 2008
D. TRANSPORTER ADJUSTMENT
PROCEDURES
I. CUTTERBAR SUPPORTS
a. Loosen four nuts on each support.
b. Slide both supports to specified location (see
previous page).
NOTE
Supports are joined by a tie angle and
move together to maintain correct
spacing.
c. Re-tighten nuts. Ensure supports are evenly
clamped onto main beam.
II. MOVING REAR AXLES
Two & Three Axle Transporter Only
a. Loosen four lower bolts (A) on each axle
support.
b. Loosen two bolts (B) on each axle support
topside.
c. Loosen outer nuts on both adjuster rods (C).
d. Turn inner nuts on both adjuster rods (C) so that
left and right frames separate approximately 3
mm from main beam.
e. Slide tandem axle assembly to desired location.
Holes are provided on adjuster plate for
attaching a winch or come-along.
NOTE
Ensure winch pulls adjuster plate straight
to avoid binding.
f. Tighten inner nuts on adjuster rods (C) against
adjuster plate.
g. Retighten all nuts and bolts. Ensure supports
are evenly clamped onto main beam.
A
B
B
C