MacDon Double Windrow Attachment - Manual (Page 56)

SECTION OM – OPERATOR’S MANUAL
Form # 169365
OM-32
Issue – May 2008
4.3 WHEELS AND TIRES
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could
engage an idling machine.
4.3.1 Wheel Nuts
IMPORTANT
Check and tighten wheel nuts after the
first hour of operation and every 100
hours thereafter. Maintain 90-120 ft-lbf
(122-163 N·m) torque using tightening
sequence as shown.
IMPORTANT
Whenever a wheel is removed and re-
installed, check torque after one hour of
operation.
4.3.2 Wheel - Removal/Installation
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could
engage an idling machine.
4.3.2.1 Removal
IMPORTANT
If transporter is not attached to towing
vehicle, block transporter wheels to
prevent movement.
a. Loosen wheel nuts slightly.
NOTE
Minimum jack capacity – 5000 lb (2270
kg).
b. Position jack and a block under frame close to
wheel.
IMPORTANT
Ensure jack locates on flat area under
frame. Do not locate on axle as damage
may occur and result in premature
failure of the suspension system.
(continued next page)
1
6
4
2
5
3