MacDon Double Windrow Attachment - Manual (Page 38)

SECTION OM – OPERATOR’S MANUAL
Form # 169365
OM-14
Issue – May 2008
IMPORTANT
If transporter is being moved without a
header on it, do not re-install pins in
weight transfer assembly. Store pins in
holes in frame.
k. If header is on transporter, re-insert pins and
washers in slotted holes weight transfer
assembly.
l. Start tractor and raise header lift legs to full
height (towing mode).
m. Stop tractor engine and remove key.
n. Engage header lift cylinder stops. See tractor
operator’s manual.
o. Remove blocks if used, from transporter
wheels.
3.6.2 Unhook From Windrower Leaving
Adapter Hitch on Transporter
The following procedure is the normal method
for unhooking the transporter from the
windrower tractor.
a. Stop tractor engine and remove key.
b. Block the transporter wheels to prevent
transporter from moving.
c. Disengage header lift cylinder stops.
d. Start tractor and activate header lift cylinders
to lower hitch to ground.
e. Stop engine and remove key.
f. Disconnect wiring harness at tractor.
g. Remove safety chain from tractor and store on
hitch.
h. Remove clevis pins from tractor legs and set
aside.
i. Start tractor and back away from hitch.
j. Re-install clevis pins into hitch boots.