MacDon Double Windrow Attachment - Manual (Page 49)

SECTION OM – OPERATOR’S MANUAL
Form # 169365
OM-25
Issue – May 2008
j. Connect center link as follows:
MECHANICAL LINK – M150
1. Loosen nut and rotate barrel to adjust
length so that link lines up with header
bracket.
2. Install pin and secure with cotter pin.
3. Tighten nut against barrel. A slight tap
with a hammer is sufficient.
HYDRAULIC LINK – M200 STD, M150 OPTION
1. Activate header tilt cylinder switches in
tractor to position center link cylinder so
that it can connect to header.
2. Push down on rod end of link cylinder
until hook engages pin on header and is
locked.
NOTE
If optional auto-connect system is
installed, activate link lift cylinder from in
the cab to lower center link onto header.
k. Activate header lift cylinders on tractor to lift
header slightly. Ensure that centerlink
securely engages pin on header. Raise
header fully.
l. Shutdown tractor engine and remove key.
m. Engage lift cylinder locks on tractor.
n. Install pins into tractor legs to secure header
boots onto legs.
o. Back slowly away from transporter.
p. Secure anchor chain to transporter support
with hairpin.
q. Re-install stabilizer wheel and crop dividers
onto header.