MacDon Double Windrow Attachment - Manual (Page 20)

SECTION UA – UNLOADING AND SETUP
Form 169365
UA-6
Issue – May 2008
III. ADJUSTING AXLE SPACING – TWO &
THREE AXLE
a. Loosen four bolts (D) on underside of axle to be
moved.
b. Loosen two bolts (E) on topside of forward axle.
c. Loosen outer nuts on the forward axle adjuster
rod (F).
d. Turn inner nuts on adjuster rod (F) so that left
and right frames separate slightly from main
beam.
e. Remove adjuster rod (G) on rear axle.
f. Remove the four bolts (H) on both sides of rear
axle mount (J).
g. Slide axle to new location and line up rear axle
mounting holes (K).
h. Re-install four bolts removed at step e. on both
sides of rear axle mount and tighten.
i. Re-install adjuster rod (G) in adjuster plate and
tighten.
j. Tighten all remaining nuts.
D
E
G
F
H
K
J