MacDon Double Windrow Attachment - Manual (Page 57)

SECTION OM – OPERATOR’S MANUAL
Form # 169365
OM-33
Issue – May 2008
c. Operate jack to raise wheel off ground.
d. Remove wheel nuts and remove wheel.
4.3.2.2 Installation
CAUTION
When installing wheel be sure to use the
holes that are countersunk to match nut
profile. The uncountersunk holes do not
seat the nuts correctly.
IMPORTANT
Be sure valve stem (A) points away from
wheel support.
a. Position wheel on spindle and install nuts.
Partially tighten.
b. Remove blocks or stand, and lower jack until
tire contacts the ground.
c. Torque nuts to 90-120 ft-lbf (122-163 N·m) in
accordance with tightening sequence shown.
d. Lower jack completely and remove from work
area.
1
6
4
2
5
3