MacDon 802 Bi-Directional Adapter - Manual (Page 11)

10
INITIAL SET-UP
PREPARING THE ADAPTER (continued)
ADJUSTING OR REMOVING THE CROP
DEFLECTOR:
Tractor Attached To Adapter:
1. If the tractor is attached to the adapter,
partially detach adapter from tractor by
following steps 3 through 7 on page 20 of this
manual.
2. Proceed with steps 3 through 7 given below.
Tractor Not Attached To Adapter:
To adjust or remove crop deflector:
1.
Drive the tractor slowly towards the adapter
until the 4x4 tubes (A) contact the loader
frame rails on the tractor. Stop engine and
engage parking brake on tractor.
2.
Attach the header lift hoses (B) to the
GREEN couplers on the tractor.
NOTE: For TV140 tractor, ensure that
“header raise” hose is installed in the
EXTEND port.
3. Raise and lower cylinder as required to drive
tractor so 4x4 tubes are 4” (100 mm) onto
tractor frame rails. Engage parking brake on
tractor.
4. Raise and lower cylinders until pins (D) are
loose then remove stands (E).
5. Slide pins (D) back so crop deflector can be
moved to new position or removed.
6. Remove bolts (F) if crop deflector is being
removed.
7. Reassemble stands (E).
POSITION TRACTOR FOR HOOK-UP
A
ATTACH LIFT HOSES
B
ADJUSTING/REMOVING CROP DEFLECTOR
D
F
E