MacDon 802 Bi-Directional Adapter - Manual (Page 30)

29
ATTACHING & DETACHING
DETACHING HEADER AND ADAPTER FROM TRACTOR (continued)
8. Swing the two adapter stands into support
position and install clevis pins, washers and
lynch pins at (A). (Retrieve pin A from storage
position on top of frame leg.) Extend foot and
secure with clevis pin, washer and lynch pin at
(B). If the ground is soft, place a piece of wood
under stands.
9. For 9030 Tractor & TV140 Tractor with
MacDon Header Drive Pump: Disconnect
pump from tractor PTO and store on torque arm
support (K).
10. Extend lift cylinders until adapter is supported
on stands.
11. Back away from adapter until tractor is just
clear of 4 x 4 tubes. Be aware of header lift
hoses, which are still connected. Stop engine
and remove key.
12. Disconnect header lift hoses at tractor. Plug or
cap all couplers to prevent hydraulic system
contamination.
NOTE: For units with hay conditioner, stand
position is as shown at (C). Be sure that frame is
resting on pin at (D). If top forming shield interferes
with header stands, extend header lift cylinders
until it clears.
ADAPTER STANDS – SUPPORT POSITION
WITHOUT HAY CONDITIONER
A
B
MacDon PUMP STORAGE
K
ADAPTER STANDS – SUPPORT POSITION
WITH HAY CONDITIONER
D
C