MacDon 802 Bi-Directional Adapter - Manual (Page 13)

12
INITIAL SET-UP
PREPARING THE 721/722 HAY CONDITIONER
This conditioner is used with 910 Series and
920/922 Auger Headers. For Model 942 and 970
Series Headers, see page 15.
1. Remove two flange nuts, front hinge support
(F), two more flange nuts and bar (J) from rear
of conditioner top cover, both sides.
2. Install rubber shield (A) by attaching its
mounting angle with 3/8 x 3/4 bolts (B)
supplied with completion package
3. Install 3/8 x 1” bolt (C), supplied with adapter
completion package, with head to outside on
left end of conditioner frame.
4. Assemble deflector (D) to right end of
conditioner frame with 3/8 x 1” bolts supplied
with adapter completion package.
DISASSEMBLE FRONT HINGE SUPPORTS
INSTALL RUBBER SHIELD
INSTALL SHORTER BOLT – L/H END
B
C
A
INSTALL DEFLECTOR – R/H END
A
D