MacDon 802 Bi-Directional Adapter - Manual (Page 17)

16
INITIAL SET-UP
PREPARING THE 741/742 HAY CONDITIONER
(continued)
4. Attach conditioner float spring to left side of
conditioner at pin (D), using the third chain link
from the end of the chain. Leave top of spring
unattached until hook-up to adapter.
NOTE: When header is in steep angle
position, it may be necessary to move to first
or second link. See header Operator’s Manual
for conditioner adjustments.
IMPORTANT: Damage to pump or hay
conditioner shield may occur if chain is too
short.
5. Install R/H hay conditioner chain mount (B) to
adapter leg with two ½ x 1 inch carriage bolts
and nuts.
NOTE: When attaching hay conditioner; to
avoid damage to conditioner drive, do not
install chain in top inboard hole. If highest
setting is required, use outboard hole (C).
ATTACH FLOAT SPRING TO CONDITIONER
D
B
C
INSTALL R/H CHAIN MOUNT